It makes sense to me to begin with lining your tartlet tins and
blind baking which means you can prep your filling whilst they are in
the oven – sounds like a plan – I hate wasting time!
The
pastry
Pre-heat your oven 180fan/200c/Gas 6.
Make sure your pastry has been allowed to come to room
temperature – it's easier to handle and it won't break. Dust your
tartlet tins with flour – on a non stick tin it's an extra
“insurance” to prevent sticking. Cut out your six large circles
and ease gently into the tins. Press a square of foil into each tin
and then add rice to each to weigh down. You'll also need six
smaller “lids” using the smaller cutter, then egg wash and
sprinkle with Nigella seeds. Bake both the bottoms and the tops for
20 minutes and check. You may need an extra 5 minutes depending on
your oven. Remove the foil and rice and discard. Allow to cool.
The
filling
Whilst your pastry is cooking you can prep your filling.
Melt the butter and rapeseed oil in a large saucepan (I used
20cms in diameter) add the onions and soften for 2/3 minutes. Set
aside in a bowl, leaving behind the residue of butter and oil. Add
the chopped mushrooms, season with salt and black pepper and cook for
2/3 minutes. Add a glug of sherry (or red wine) and then let the
mushrooms cook, absorbing the liquid. You don't have to add the
alcohol but what is certain is that it brings out the flavour of the
mushrooms. Add the onions and walnuts, check your seasoning and
adjust to your taste. Add the parsley and then the cream and heat
gently stirring, then add the cornflour a little at a time until you
get a rich thick filling.
Cool and then fridge – leave in the pan if you intend to
serve that day.
When you're ready to assemble place your tart base on a baking
sheet, add a scoop of filling and then gently add your lid. I used a
heaped ice cream scoop, measuring 5cm in diameter for portion
control. Bake in a pre-heated oven as above for 15 minutes and then
serve.
P.s. For the avoidance of doubt – a glug is a tablespoonful!
Photo guide – in two parts – up next.
No comments:
Post a Comment